Free shipping on orders over $60!

0

Your Cart is Empty

Installation

We understand the challenges you can face when working with your vehicle’s power system.  It can be both dangerous to you and your vehicle if you don’t know what you are doing.  Have one of our experience techs install your dashcam for you.  We will have you on the road enjoying your new dashcam in no time.    Contact us to make an appointment.  

Basic installation steps can used on any car:

Attach the dashcam to the windshield first before concealing the cord. Before doing so, clean the suction cup and the windshield with a wet cloth. Follow the steps below for basic concealing:

Step 1: Run the cord from the dash camera to the windshield headliner. You can attach the cord of the dashcam to the existing wire of your rear view mirror if there is using the electrical tape. The part of the car where the roof and windshield meets is called a “Lip”. You can tuck the cord above the lip to completely hide it.

Step 2: Hide the cord above the lip of the windshield headliner. Hide it by running the cord at the back of the headliner and then curving it going down the corner. Tape, glues, or cable clips can be used to attach the corners.

Step 3: Bring the cord out of the end of the headliner and curve going down to the edge of the windshield. The cord can nestle into the edge where the interior of the car meets the windshield. 

Step 4: Run the cord going down the edge of the windshield and then attach it. The cord can nestle into the edge where the interior of the car and windshield meets.

Step 5: When you were done with attaching the cords all the way going down the edge of the windshield as described in step4, you can curve the cord towards the dashboard and then run it along the edge.

Step 6: Wrap the cord around the corner of the frame or the dashboard. This is optional.

Step 7: Attach or tuck the wire into the molding and run it down the edge. This part of the car is usually not being seen when the car door is closed. If the wire cannot be tucked, use a tape, cable clips, or glue to hold it in its place. Do not worry if this part won’t look pretty since it can be concealed by the door. 

Step 8: Run the cord down the floor mat or the glove box. You can fasten the cord tightly by using tapes, glue, or cable clips.

Step 9: Run the cord all the way up to the power outlet, the cigarette lighter, or PowerMagic.

Step 10: Drop the wires into the fuse panel area and connect the ground wire to the bolt indicated in the image. You will need to remove the kick panel trim to make accessibility easier. Simply unscrew the plastic nut on the right side and unclip.

Step 11: Prepare your fuse taps and crimp them to the Power Magic Pro Constant and Switched wires.

Step 12: You can now connect the fuse taps to the fuse box. Where required remove the existing fuse and insert into the fuse tap. Then add a new 2.5a or 5a fuse to service the dashcam wiring.

Step 13: You can now connect the fuse taps to the fuse box. Where required remove the existing fuse and insert into the fuse tap. Then add a new 2.5a or 5a fuse to service the dashcam wiring.

Step 14: Turn on your vehicle (Ensure you start the engine) and test dash cam operation. You can now reinstall all trim panels and enjoy your dash cam.

Nothing comes easy at first try, but, installing a dashcam is not as hard as you thought it could be. Having a dashcam nowadays is very important, and installing it properly can help you have a clear sight of the road. Aside from choosing a top quality dash cam with quality video, it should also have at least 2 meters long cord for easy installation.

Subscribe